Electrician

Key Roles & Responsibilities

1. Electrical Installation & Commissioning

• Install electrical wiring, conduits, cable trays, and power cables.

• Install and commission motors, pumps, blowers, agitators, dosing pumps, and other electrical equipment.

• Install and terminate control panels, MCCs, PCCs, APFC panels, and distribution boards.

• Ensure proper earthing and lightning protection systems are installed.

2. Preventive & Breakdown Maintenance

• Carry out preventive maintenance as per maintenance schedules.

• Attend electrical breakdowns and restore equipment with minimum downtime.

• Inspect electrical equipment for abnormal noise, overheating, vibration, and insulation failure.

• Replace faulty electrical components such as contactors, relays, MCBs, MCCBs, fuses, timers, and overload relays.

3. Motor & Pump Maintenance

• Perform maintenance of HT/LT motors and centrifugal pumps.

• Check motor insulation resistance (IR) and winding condition.

• Align motors with pumps after maintenance.

• Monitor motor current, voltage, and temperature.

4. Control Panel Maintenance

• Maintain MCC, PCC, PLC, VFD, and control panels.

• Tighten electrical connections and clean panel interiors.

• Check healthiness of relays, indicators, timers, and control circuits.

• Assist in PLC and SCADA-related electrical troubleshooting.

5. Instrument & Field Equipment Support

• Assist in installation and maintenance of:

  • Level transmitters

  • Pressure switches

  • Flow meters

  • pH and DO analyzers

  • Limit switches and sensors

• Coordinate with instrumentation technicians during calibration and commissioning.

6. Electrical Testing & Troubleshooting

• Diagnose faults in electrical circuits and equipment.

• Use multimeters, clamp meters, insulation testers (Megger), and phase sequence meters.

• Perform continuity, insulation resistance, voltage, and current testing.

• Identify cable faults and rectify electrical issues.

7. Generator & Power Backup

• Operate and monitor DG sets during power failures.

• Perform routine maintenance checks on generators.

• Monitor ATS (Automatic Transfer Switch) operation.

8. Safety Compliance

• Follow electrical safety standards and Lock-Out/Tag-Out (LOTO) procedures.

• Use appropriate PPE while performing electrical work.

• Ensure safe isolation before maintenance activities.

• Report unsafe conditions and electrical hazards immediately.

• It is a Full Time Electrician job for candidates with 6 months - 1 years of experience.